![]() Stainless Steel Kickplate - Left Hinge - (7010359)ĭual Installation Kit with 66" Grille Frame - (7012623)ĭual Installation Kit with 66" Pro Louvered Grille - (7012624)Ħ6" Dual Flush Inset Stainless Grille Panel - (7013367)įramed Louvered Grille Insert - (7014849) ![]() Stainless Steel Kickplate - Right Hinge - (7010358) Stainless Steel Dual Flush Inset Door Panel with Pro Handle - (7010274) Stainless Steel Flush Inset Door Panel with Pro Handle - (7010268) Stainless Steel Flush Inset Grille Panel - (7008870)Ħ0" Dual Flush Inset Stainless Grille Panel - (7008882) ![]() More than 1/ 2” (13 mm) to 3/ 4” (19 mm) of bit is protruding.ĥ Attach the heater to the unit using the #8-32 × 1/ 2" pan head screws into the drilled holes.Dual Installation Kit with 60" Louvered Grille - (7004808)ĭual Installation Kit with 72" Louvered Grille - (7004809)ĭual Installation Kit with 60" Grille Frame - (7004810)ĭual Installation Kit with 72" Grille Frame - (7004811)ĭual Installation Kit with 60" Pro Louvered Grille - (7004812)ĭual Install Kit with 72" Pro Louvered Grille - (7004813) Short drill bit inserted into the drill chuck so that no Note: To avoid drilling through the inner liner, use a Note: The heater assembly MUST be attached to the right side of the left-hand unit.ġ Clear the foil from the mounting holes of the heater assembly.Ģ Place the heater against the right-hand side of the unit with wires up and foil side in, positioning the heater 2” (51 mm) from the top edge of the cabinet and 1” (25 mm) from the rear edge of the cabinet.ģ Using the heater as a template, mark the heater mounting holes on the cabinet with a pencil, then remove the heater.Ĥ Drill a 7/ 64" (3 mm) hole at each marked location. If a Built-In unit were to tip and fall, it could cause serious injury or death! The front leveling legs of a Built-In unit must be extended to the floor to complete the installation. The anti-tip components supplied with Built-In units must be used as specified in the installation guide. ![]() When moving a Built-In unit, keep the doors and drawers taped closed. Built-In units are heavy and can be unstable when attempting to install them. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |